Specifications - Emotiva miniX A-100 User Manual

Specifications

Analog inputs:
Unbalanced (RCA); one stereo pair
Analog outputs (loop):
Unbalanced (RCA); one stereo pair
Input sensitivity (for full output):
600 mV (8 ohm load)
Speaker outputs:
5-way binding posts; one stereo set
Minimum recommended load impedance:
4 ohms (which equals one 4 ohm load or two paralleled 8 ohm loads per channel)
Power output:
50 watts / channel RMS; continuous into 8 ohms; 20 Hz - 20 kHz;
<0.05% THD; both 2 channels driven (FTC)
80 watts / channel RMS; continuous; into 4 ohms
S/N ratio:
> -95 dB (A-weighted)
Frequency response:
20 Hz to 20 kHz + / - 0.08 dB at 1 watt (- 1 dB at 80 kHz)
Front panel controls and indicators:
Volume; analog potentiometer with machined aluminum knob, illuminated Status ring, and pinpoint
Position LED (Illuminated ring changes color to indicate status)
Back panel controls:
AC Power switch
Line Voltage (protected slide switch)
Power Mode switch (On, Off, Auto)
Trigger and control:
Trigger Input: 5-12 VDC
Auto-sense of audio input signal
Trigger Output: 12 VDC 120 mA max
Protection:
The Mini-X A-100 is protected against excessive operating temperature, shorted
speaker connections, ground faults, and other common fault conditions. If a fault occurs, the Mini X
will return to Standby mode and the illuminated ring (around the Volume control) will flash Amber to
indicate a fault condition.
Power requirements:
115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (selectable by rear-panel switch)
Dimensions:
8.5" wide x 3.125" high x 15" deep (includes feet, binding posts, and Volume knob)
Weight:
11.8 lbs ; 15 lbs (packaged)
Page 13