Lexmark E322 - Printer - B/W Setup Manual page 4

Printing
Paper handling
Maintenance
Troubleshooting
Administration
Index
Requirements
You must run the Print Server TCP/IP Setup Utility on a Windows 95/98/Me, Windows NT 4.0,
or Windows 2000 workstation.
The print server must be on the same physical subnet as your workstation. In other words,
the Print Server Setup Utility cannot cross routers, bridges, and so forth.
Installation
1
Launch the drivers CD.
2
Click Install Software, Printer Software.
3
Click Custom Install when you see this option.
4
Select Network Support, and then click Next.
5
On the Network tab, select Print Server TCP/IP Setup Utility, and then Finish
Installation.
Static ARP entry and telnet
To set the print server IP address, netmask, and gateway using this method, you add a static
entry to the ARP table on some computer that is on the same IP subnet as the print server.
(Source Route bridging is not supported.) Then, you use telnet.
To set the IP address, netmask, and gateway using static ARP entry and telnet:
www.lexmark.com
Lexmark E320/E322 Printer
Setting up the network printer 4