Table of Contents
Advertisement
Remote Gateway IP
Remote Network IP/
Remote Network Mask
More
RIP Direction
RIP Version
For NAT operation, treat
remote sub-net as
Change default route to
this VPN tunnel
Vigor2910 Series User's Guide
address from the remote router during the IPCP negotiation
phase. If the PPP IP address is fixed by remote side, specify
the fixed IP address here. Do not change the default value if
you do not select ISDN, PPTP or L2TP.
This field is only applicable when you select ISDN, PPTP or
L2TP with or without IPSec policy above. The default value is
0.0.0.0, which means the Vigor router will get a remote
Gateway PPP IP address from the remote router during the
IPCP negotiation phase. If the PPP IP address is fixed by
remote side, specify the fixed IP address here. Do not change
the default value if you do not select ISDN, PPTP or L2TP.
Add a static route to direct all traffic destined to this Remote
Network IP Address/Remote Network Mask through the VPN
connection. For IPSec, this is the destination clients IDs of
phase 2 quick mode.
Add a static route to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction
here. Herein, we provide four options: TX/RX Both, TX Only,
RX Only, and Disable.
Select the RIP protocol version. Specify Ver. 2 for greatest
compatibility.
While communicating with remote subnet, the router can treat
it as private subnet by sending packets with the router's
private IP address, or treat it as public subnet by sending
packets with the router's public IP address.
Check this box to change the default route with this VPN
tunnel. Be aware that this setting is available only for one
WAN interface is enabled. It is not availabe when both WAN
interfaces are enabled.
103
Advertisement
Table of Contents
