Setting Up Your Morgan Wood Fireplace Insert; Unpacking; Installing Your Fireplace Insert; Hearth Requirements And Floor Protection - HearthStone 8470 Owner's Manual

U
NPACKING
Hearthstone Stoves packages your Morgan Fireplace
Insert with the greatest care, so that it ships safely. Under
certain circumstances, however, damage can occur during
transit and handling. When you receive your Fireplace
Insert, unpack it carefully, inspecting your Fireplace
Insert and all parts for damage. Also, make sure that all
parts are included in the box. If any parts are damaged or
missing, please contact your dealer immediately.
I Y F
NSTALLING OUR IREPLACE
When Installing this unit in a fireplace, you must attach
the metal label provided (3300-625) to the fireplace prior
to installing the insert. To install the tag,
Make sure that the Fireplace Insert will have enough
clearance to combustible materials that would surround
the insert. These combustibles can include walls, floor,
ceiling, fireplace, and chimney.
consider the clearances to all of these combustibles before
actually connecting your Fireplace Insert.
Read this chapter to obtain a sound understanding of how
to properly install your Fireplace Insert.
If you use a close clearance connector pipe, it must be
tested to UL standards and listed. Check the listing of
your pipe for actual clearances. The diagrams in this
manual represent typical installations, but are specific to
the Simpson Dura-Vent DVL brand. Clearances cannot
be reduced without the use of close clearance connector
pipe and/or by protecting the surfaces per NFPA 211
standards.
National Fire Protection Agency
Batterymarch Park
Quincy, MA 02269
1-800-344-3555
1-617-770-3000
Hearthstone Quality Home Heating Products, Inc. ®
Setting up Your Morgan
Wood Fireplace Insert
I
NSERT
You must carefully
5
Figure 2 Minimum Fireplace Dimensions
H R
EARTH EQUIREMENTS
P
ROTECTION
Combustible flooring must be protected with a covering
of noncombustible material (slate, marble tiles, other
noncombustible material can be used for this purpose).
The floor protection must extend beyond the body of the
Fireplace Insert at the minimum as follows and have a
minimum "R-Value" of 1.0.
Hearth must be of a
non-combustible material
with an "R-Value" of at
least 1.0
Figure 3 Hearth Requirements
* Installations in Canada require 18" (45.72 cm) of floor
protection in the front.
A F
ND LOOR
From
fuel
door
opening
Morgan Model 8470