Code 11 Set Length 1 - Datalogic Gryphon I GD4100 Product Reference Manual

Symbologies
Code 11 — cont.

Code 11 Set Length 1

This feature specifies one of the barcode lengths for
minimum label length if in
Mode. Length includes the barcode's check and data characters.
The length can be set from 2 to 50 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODE 11 LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 31. Code 11 Length 1 Setting Examples
STEP ACTION
Desired Setting (pad with
1
leading zeroes)
2
3
Scan Two Characters From
4
Appendix E, Keypad
5
252
Variable Length
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
length setting which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
02 Characters
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT CODE 11 LENGTH 1 SETTING
'0' and '2'
Scan ENTER/EXIT PROGRAMMING MODE
Code 11 Length
Mode, or the first fixed length if in
Appendix E,
31 for some examples of how to set this feature.
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Control. Length 1 is the
Fixed Length
Keypad, that represent the
50 Characters
'5' AND '0'
Gryphon™ I GD4100