Ack Nak Retry Count - Datalogic Gryphon I GD4100 Product Reference Manual

RS-232/USB-Com Interfaces

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and
a selection of 255 specifies unlimited retries.
To set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005,
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT ACK NAK RETRY COUNT SETTING.
5. Scan the appropriate three digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 11. ACK NAK Retry Count Setting Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3
4
Scan Three Characters
5
From Appendix E, Keypad
6
70
20 = 020, etc.
Mode.
number which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
Disable Retry
Count
000
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT ACK NAK RETRY COUNT SETTING
'0' , '0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix E,
11 for some examples of how to set this feature.
EXAMPLES
3 Retries 54 Retries
003 054
'0' , '0' and '3' '0' , '5' and '4'
Keypad, that represent the
Unlimited Retries
255
'2' , '5' and '5'
Gryphon™ I GD4100