Datalogic 2 Of 5 Set Length 2 - Datalogic Gryphon I GD4100 Product Reference Manual

Datalogic 2 of 5 — cont.

Datalogic 2 of 5 Set Length 2

This feature specifies one of the barcode lengths for
the maximum label length if in
Length
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50, or 0 to ignore this length). The
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT Datalogic 2 of 5 LENGTH 2 SETTING.
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 28. Datalogic 2 of 5 Length 2 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to
2
yield two digits
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
Product Reference Guide
Mode. The length includes the barcode's check and data characters.
length must be an even number.
20, etc.
Mode.
length setting which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
Ignore This Length
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT DATALOGIC 2 OF 5 LENGTH 2 SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Datalogic 2 of 5 Length
Variable Length Mode, or the second fixed length if in
28 for some examples of how to set this feature.
EXAMPLES
4 Characters
04
'0' and '4'
Datalogic 2 of 5
Control. Length 2 is
Keypad, that represent the
Appendix E,
14 Characters 50 Characters
14
'1' and '4' '5' AND '0'
Fixed
50
225