Label Id: Set Individually Per Symbology - Datalogic Gryphon I GD4100 Product Reference Manual

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a barcode to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
NOTE
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 9. Label ID Position Options
Product Reference Guide
fix) by scanning the appropriate barcode in the section "Label ID Control"on page 117.
Reference Figure 9 for Label ID positioning options if multiple identification features are
enabled.
ID from the section
Label ID Symbology Selection, starting on page
Label ID for the selected symbology.
on the inside back cover of this manual and find the equivalent hex
ASCII Chart
digits associated with your choice of Label ID. For example, if you wish to select an equal
sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 301
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in Table 18.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Prefix Label ID Aim ID
and scan the barcodes representing the hex characters deter-
Bar Code Data Label ID
OR
118.
Suffix
Label ID
115