Advertisement
Quick Links
IMPORTANT NOTE!
This gauge has an hour meter and
odometer preset option available only
for the first 1.0 engine hour and 10
miles (16km). See "ODO/HR
PRESET" for instructions.
Operation menu
Left switch functions
Pressing the left switch during normal gauge operation will move through the below commonly viewed functions
for convenience.
00000. 0
12: 0 0A
H
0. 0
Right switch functions
Pressing the right function switch during normal operation will scroll through the following display functions. A
heading will first appear after each press to display the currently selected function. After about 2 seconds, the
display will show the data for the selected function.
Heading
trip A
trip b
srv mi(srv km)
srv hr
mph(KPH)
tach
2008 Yamaha Rhino
Odometer
Clock (hold left switch to set)
Setting clock:
Left switch press moves between hours and minutes
Right switch press changes current value
Hold left switch again to exit clock set mode
Hourmeter
Data
a
0. 0
b
0. 0
s 0000
sh 000
00 mph(00 KPH)
r 0000
UTV-1200
Multi Gauge for
Description
Trip A (hold right switch to reset)
Trip B (hold right switch to reset)
Count down Service odometer if enabled (hold right switch to reset)
Count down service hour meter if enabled (hold right switch to reset)
Alternate speed display (hold right switch to change primary unit)
Tachometer displays in information center
page 1
MAN#650244:A
Advertisement
Related Manuals for Dakota Digital UTV-1200
Summary of Contents for Dakota Digital UTV-1200
- Page 1 IMPORTANT NOTE! This gauge has an hour meter and odometer preset option available only UTV-1200 for the first 1.0 engine hour and 10 miles (16km). See “ODO/HR Multi Gauge for PRESET” for instructions. 2008 Yamaha Rhino Operation menu Left switch functions Pressing the left switch during normal gauge operation will move through the below commonly viewed functions for convenience.
-
Page 2: Installation
INSTALLATION: Disconnect the battery to prevent possible damage to the electrical system or gauge during install. Remove the stock gauge or indicator panel (see service manual for removal instructions). The UTV gauge will mount in this mounting location. Remove the seats, console/engine cover, front engine cover, and center floor/front drive shaft cover (refer to service manual). - Page 3 SPEED Speed gauge menu UNIT Select unit for speed Toggle between MPH and KPH (select unit to use for calibration) AUTO Auto calibrate speed to a marked mile or kilometer Pulls up all values on speed and speed pulses in odometer Press Right switch to finish cal and save value ADJUST Adjust speed cal while driving...
-
Page 4: Speed - Adjust
ADDITIONAL SETUP NOTES SPEED – AUTO This setup option allows calibrating to a known mile or kilometer. By default, the speed is calibrated to use the Rhino Factory speed signal. Calibration should only be needed if the factory calibration is no longer correct due to changes to tires or gearing. -
Page 5: Troubleshooting
OPTION – DIM OUT The dim out option allows the dim output to be turned on or off. The dim output is used if you have installed other Dakota Digital gauges and would like this gauge to also control the dimming of these gauges. If the dim out option is turned on, 12v is sent out on the dim out wire when the gauge is dimming. -
Page 6: Service And Repair
Any action for breach of any warranty hereunder, including any implied warranty of merchantability, must be brought within a period of 24 months from date of original purchase. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.