D-Link DVG-5112S User Manual page 8

DVG-5112S User's Manual
DVG-5112S in a NAT network
Under this mode, the gateway uses a virtual IP address and the IP sharing function of other systems to
connect to the Internet.
LAN IP address for IP sharing
DVG-5112S IP Settings
NAT /STUN Settings
(Please refer to page 14 for
information on using NAT.)
DDNS Settings
(Please refer to page 14 for
information on DDNS settings.)
VSP
D-Link Systems, Inc.
Please avoid IP addresses in the following range:
192.168.8.1-192.168.8.254 (You may need to change the settings of
IP sharing or change SIP series gateway LAN Port IP addressing)
Set as static IP address, and assign the LAN IP address of the IP
sharing to the Default Gateway.
If the WAN of the IP sharing device has a static IP address,
then the NAT IP address is set as the Public IP address for
IP sharing.
Enable
If the WAN of the IP sharing device uses a dynamic IP
address, then the gateway has to comply with the DDNS
settings. When using NAT, you must enter the URL
(Uniform Resource Locator) that is registered to the DDNS
server.
The WAN of the IP
sharing device has a
static IP address.
The WAN of the IP
sharing device has a
dynamic IP address.
Router/
IP Sharing
Leased Line/ ADSL
/Cable Modem
Disabled
Enabled: enter the registered URL (Uniform
Resource Locator) into the network settings
under NAT
8