Dtmf & Pulse - D-Link DVG-5112S User Manual

DVG-5112S User's Manual
3-22 DTMF & Pulse
Dial Wait Timeout: Use this variable to set the wait time for the user's first key pressing when dialing a
number. The user will hear a busy tone if he or she does not press the first key within the set time
frame.
Inter Digits Timeout: Set the waiting time between each key press. The numbers input up to that
point will be dialed after the timeout.
Minimum DTMF ON Length (Dial on)/ Minimum DTMF OFF Length (Dial off - between tones):
Used to set the dial tone when a call is being diverted to another extension.
DTMF Detection Sensitivity: Used to adjust the sensitivity of the telephone keys.
Enable Out-of-Band DTMF: To send DTMF keys (0~9, *, #,) follow the RFC2833 rules or via SIP Info.
NOTE: Out-of-Band DTMF transport method may vary with different VoIP networks, please
contact your VoIP provider for their preferred method.
Payload Type: payload type of RFC2833.
Volume: Defines the volume of RFC2833.
Enable Hook Flash Event: To send Hook Flash event when enabled Out-of-Band DTMF.
Disable: Not to send Hook Flash event.
Auto: To send Hook Flash event followed the type of Out-of-Band DTMF.
SIP_INFO: To send Hook Flash event by SIP_INFO even Out-of-Band DTMF is RFC 2833.
RFC_2833: To send Hook Flash event by RFC 2833.
D-Link Systems, Inc. 39