Lorex VANTAGE LH110 ECO SERIES Instruction Manual page 162

Troubleshooting
Troubleshooting (cont'd.)
Error Possible Causes
• Mouse not detected • Mouse cable is not firmly
by system connected to the system
• Mouse is not connected to the
system
• System needs to be reset
• There is no picture • Camera cables are loose or
on selected channels have become disconnected
/ camera picture is
not being displayed
• The image on the • Audio cables are loose or have
DVR appears, but been disconnected
does not have sound
• Audio channels are disabled in
the system menu
• Volume on external speakers
(not included) is low or off
• The system beeps
at startup
• The system beeps • Motion detection is enabled, but
during motion the alarm buzzer is activated
detection
• I am not receiving • Email notification is disabled
email notifications
• Default setting is disabled, but
you have not entered your own
SMTP information
148
Solutions
• Firmly connect the mouse cable to the USB Mouse
port on the front panel
• Power off the system (disconnect power cable).
Firmly connect a USB mouse to the USB Mouse port
on the front panel of the system. Reconnect the
power cable to the DC 12V port on the rear panel.
• Check the camera video cable and connections
• Disconnect and reconnect the cable at the system
and at the camera
• Try moving the camera to another channel or use
another cable
• Check the AUDIO connections to the DVR
• Check the Configurations: Main Menu
the Audio drop-down menu, select Enable, and click
Apply
• Increase volume on external speakers (not
included)
• The beep at startup is normal
• Open the Main Menu and click DEVICE
• In the Buzzer drop-down, select Off. Click apply.
>
• Open Main Menu Device
Setup button. In the Email drop-down menu, select
Default. Enter the Sender and receiver email. Click
Apply.
• If you want to use your own SMTP server, deselect
the Default box, and enter your SMTP Server
address, Port, User name, and Password in the
respective fields
>
Record. In
>
Alarm
>
Alarm. Click the Email