Lorex VANTAGE LH110 ECO SERIES Instruction Manual page 155

PTZ Menu
The system is capable of manipulating PTZ cameras (not included) that are connected to
the system. Please note that you will need PTZ information from the PTZ manufacturer's
users guide.
To configure the PTZ Parameters menu:
1 Click REMOTE CONFIG>Device>PTZ Parameters.
PTZ Parameters
2 Configure the following:
• Channel: Select the channel that the PTZ camera connects to
• Protocol: Select the protocol of the PTZ camera*
• Baud Rate: Select the baude rate of the PTZ camera*
• Data Bits: Select the data bit rate of the PTZ camera*
• Stop Bits: Select the stop bit rate of the PTZ camera*
• Verify: Select from Odd, Even, Mark, or Space.*
• Cruise: Select enable or disable.*
• Address: Select the address of the PTZ camera*
*Consult the PTZ camera's instruction manual for protocol and configuration details
Optional: Click the Copy Settings To button to copy the PTZ settings to different channels.
3 Click Save to apply your settings.
• For details on connecting a PTZ camera to your system, see "Appendix H: Connecting a PTZ
Camera" on page 112.
Configuring the system remotely
141