Low Profile USB 2.0 Quick Installation Guide Features and Benefits • Compliant with USB specifications revision 2.0 • Conforms to PCI specifications revision 2.2 • Supports simultaneous operation of multiple high-speed USB 2.0 and USB 1.1 devices • Supports high-speed (480 Mbps), full-speed (12 Mbps), and low-speed (1.5 Mbps) data transfer modes •...
Package Contents • Low Profile USB 2.0 • Quick Installation Guide Layout Internal port External ports Figure 1: Layout Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed.
Remove the slot bracket from an available PCI slot. Carefully align the card to the selected PCI slot, push the board down firmly, but gently, until it is well seated. Replace the slot bracket holding screw to secure the card. Replace the computer cover and reconnect the power cord.
Page 4
The drivers show up differently under different versions of Windows. Please refer to the correct Windows version to verify. For Windows 7 / Vista: Under Universal Serial Bus controllers, NEC to PCI Universal Host Controller will be displayed two times and Standard Enhanced PCI to USB Host Controller will be displayed one time.
Step 1: Submit your RMA request. Go to www.siig.com, click Support, then RMA to submit a request to SIIG RMA. If the product is determined to be defective, an RMA number will be issued. Step 2: After obtaining an RMA number, ship the product.
Page 8
Fremont, CA 94538-3152, USA Phone: 510-657-8688 Low Profile USB 2.0 is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft, Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Pentium is a registered trademark of Intel Corporation.