Hitachi CM771ET User Manual page 6

Flat face colour monitor with easymenu, chassis dj72
Hide thumbs Also See for CM771ET:
Table of Contents

Advertisement

( C o n t i n u e d )
This equipment relies on the protective devices in the building installation for
number and location of the protective devices which should be provided in the building
protective devides
Case A:
Equipment to be Earth faults
connected to POWER SYSTEMS Overcurrent
with earthed neutral reliably
identified, except for Case C
below.
Case B:
Equipment to be Earth faults
connected to any supply,
including IT POWER SYSTEMS
and supplies with reversible
plugs, except for Case C below.
Equipment to be Earth faults
Case C:
connected to 3-wire power Overcurrent
Verify that the protective devices in the building installation meets the conditions in the
table prior to installing the equipment.
To prevent electrical shock by the static electricity on the CRT surface, disconnect the
power cord at least 30 seconds after turning OFF the power.
Do not repeat OFF and ON power switching in a short period.
colours or distortion of the displayed pattern.
After the power has been turned ON or when the degauss function has been manually
engaged, the CRT is demagnetised for approximately 7 seconds. This generates a
strong magnetic field around the front cover which may affect the data stored on
magnetic tape or disks near the front cover.
and tapes/disks away from this unit.
Before cleaning, turn OFF the power switch and disconnect the plug from the power outlet.
For the screen, use water with a lightly moistened soft cloth such as a gauze type material.
For the cover, use water or a liquid synthetic detergent, with a lightly moistened soft cloth.
Do not clean the rnsrde
of monitor by yourself as it is very dangerous.
Do not use aerosol sprays, solvents or abrasive cleaners.
l - 4
Informative examples of
in
single - phase equipment or sub - assemblies
Protection Minimum number
of fuses or circuit
against
Overcurrent
Place
Location
1
Phase conductor
1
Either of the two
conductors
2
Both
conductors
1
Either of the two
conductors
2
Each phase conduct0 r
2
Each phase conduct0 r
I
This may cause blurred
such
magnetic
recording
Refer to your dealer.
equipment

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cm772etCm771euCm772euCm771et/uCm772et/u

Table of Contents