Installing A Dc Terminal Cover - IBM 87401RU Installation And User Manual

Installing a dc terminal cover

There are two types of terminal covers, depending on the date of manufacture. The
following illustrations show both types of terminal covers.
Screws
To install a dc terminal cover on an IBM BladeCenter HT type 8740, complete the
following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure power has been disconnected from the BladeCenter HT unit. See
3. Turn off the power source.
4. If your terminal cover has screw holes, orient the terminal cover so that it fits
5. If your terminal cover does not have screw holes, snap the cover into place so
DC terminal
cover
Locking tabs
DC terminal
cover
on page 26.
"Disconnecting power from the BladeCenter HT unit" on page 16 for more
information.
Note: After you disconnect the BladeCenter HT unit from power, wait at least 5
seconds before you connect the BladeCenter HT unit to power again.
over the dc power terminals and the screw holes on the terminal cover are
aligned with the screw holes on the dc power box. Install the two phillips-head
screws that attach the terminal cover to the power box.
that the locking tabs go into the slots on the side of the power terminals.
Chapter 3. Installing the BladeCenter HT unit and options
61