Installing an I/O-module interposer
Note: Before you install a new I/O-module interposer, read the documentation that
To install an I/O-module interposer, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the module filler and filler tray, if one is installed (see "Removing an I/O
3. Make sure that the release handle is in the open position.
4. Slide the module into the module bay until it stops.
5. Push the interposer release handle to the closed position.
6. Install an I/O module or filler (see "Installing an I/O module" on page 53).
52
BladeCenter HT Type 8740 and 8750: Installation and User's Guide
comes with the interposer for detailed instructions.
I/O filler tray
I/O bay filler
Handle
(open)
on page 26.
module" on page 33 and "Removing an I/O-module interposer" on page 34).
I/O module interposer