Removing components from a BladeCenter HT unit
The following procedures are for removing components or optional devices from the
BladeCenter HT unit.
Removing a cable management tray
The cable management trays can be installed with or without the BladeCenter HT
bezel. To remove the cable management trays and the BladeCenter HT bezel, see
the IBM BladeCenter HT Bezel Installation Instructions for more information.
To remove a cable management tray that is installed without the BladeCenter HT
bezel, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Hold the cable management tray with one hand and use a phillips-head
3. Pull the cable management tray away from the BladeCenter HT unit.
4. Repeat these steps for the other cable management tray.
28
BladeCenter HT Type 8740 and 8750: Installation and User's Guide
Upper cable
management tray
Thumb
screws
Thumb
screws
on page 26.
screwdriver to loosen the captured thumb screws that attach the cable
management tray to the BladeCenter HT unit.
Lower cable
management tray