Network Setup Menu - Cisco 6921 - Unified IP Phone Standard VoIP Administration Manual

Network Setup Menu

Network Setup Menu
The Network Setup menu provides options for viewing and making a variety of network settings.
Table 4-1
For information about how to access the Network Setup menu, see the
Menu" section on page
For information about the keys you can use to edit options, see the
Table 4-1 Network Setup Menu Options
Option
IPv4 Setup
Host Name
Domain Name
Operational VLAN ID
Admin. VLAN ID
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
4-4
describes these options and, where applicable, explains how to change them.
4-2.
Description
In the IPv4 Setup submenu, you can do the following:
• Enable or disable the phone to use the IP address that
is assign by the DHCP server.
• Manually set the IP Address, Subnet Mask, Default
Routers, DNS Server, and Alternate TFTP servers.
For more information on the IPv4 address fields, refer to
Table 4-2.
Unique host name that the DHCP server assigned to the
phone.
Name of the Domain Name System (DNS) domain in
which the phone resides.
Auxiliary Virtual Local Area Network (VLAN)
configured on a Cisco Catalyst switch in which the phone
is a member.
If the phone has not received an auxiliary VLAN, this
option indicates the Administrative VLAN.
If neither the auxiliary VLAN nor the Administrative
VLAN are configured, this option defaults to a VLAN ID
of 4095.
Auxiliary VLAN in which the phone is a member.
Used only if the phone does not receive an auxiliary
VLAN from the switch; otherwise it is ignored.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
"Displaying a Configuration
"Editing Values" section on page
To Change
Scroll to IPv4 Setup and press
Select.
Display only—Cannot configure.
1. Set the DHCP Enabled option to
No.
Scroll to the Domain Name
2.
option, press the Edit softkey,
and then enter a new domain
name.
Press the Apply softkey, then
3.
press Save.
Display only—Cannot configure.
The phone obtains its Operational
VLAN ID via Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use the
Admin VLAN ID option.
1. Scroll to the Admin. VLAN ID
option, press the Edit softkey,
and then enter a new Admin
VLAN setting.
Press the Apply softkey, then
2.
press Save.
4-3.
OL-19025-01