Section 3 Using The Handset; Acquiring Link; Lcd Display Indicators - NEC DTH-4R-2 - CORDLESS Lite II BLAC Owner's Manual

NEC Unified Solutions, Inc.
To restore the REDIAL key to the redial function:
1.
2.
3.
S 3 U
ECTION
When using the handset, different status indications are displayed in the
handset LCD.

Acquiring Link

When the TALK key on the handset is pressed, the
handset attempts to connect to the base unit. The
ACQUIRING LINK message blinks on the handset
display (300 msec ON/300 msec OFF) to indicate
that connection is in progress.
After the connection is made between the handset
and base unit, a message is displayed in the LCD to indicate the condition of
the handset. Refer to
conditions.
term ™
D Cordless II Owner's Guide
Enter setup mode (refer to steps 1~5
Using a Softkey on page 4-6
Press the F3 key and then the HOLD key. Digital (Redial) is displayed in the
LCD indicating that the redial function has been restored to the REDIAL key.
Press the TALK key once to restore the handset to standby mode.
H
SING THE ANDSET
Condition
Line OK
No Connection to Base Unit
Channel Busy
Line in Use
No Line Selected
Switching from Desk to Cordless
).
Table 4-2 LCD Display Indicators
Table 4-2 LCD Display Indicators
Indicator
TALK Icon
Error Tone
Error Tone
Error Tone
TALK Icon
Document Revision 3
for a list of possible
LCD Display
N/A
NO SERVICE
SYSTEM BUSY
LINE IN USE
NO LINE SELECTED
4 - 7