Table of Contents
Advertisement
Other Functions
4. Press the [ADJ] button again to return to the
STANDARD display.
Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from the
unit, this indicator blinks.
The factory default setting is "OFF".
1. When the panel is open, press the [ADJ] but-
ton to display the adjustment selection display.
2. Touch the [BLINK LED] key to select "ON" or
"OFF".
3. Touch the [ON] or [OFF] key to select a de-
sired mode and set it.
4. Press the [ADJ] button again or touch the
[RTN] key. The unit returns to the previous
mode.
Adjusting the dimmer level
You can adjust the reduced illumination level of
the dimmer. When driving at night with the inside
of the car, the auto dimmer function can reduce
the display illumination linked "to the illumination
power supply of the car" in this unit in order to
prevent glare from the display.
The factory default:
When the car light is off: Brightest setting
When the car light is on: Medium brightness
1. When the panel is open, press the [ADJ] but-
ton to display the adjustment selection display.
2. Touch the [DIMMER LEVEL] key to adjust the
dimmer level.
3. Touch the [+] or [–] key to adjust.
4. Press the [ADJ] button again or touch the
[RTN] key two times.
The unit returns to the previous mode.
Setting the button illumination
The factory default setting is "RED" (red).
1. When the panel is open, press the [ADJ] but-
ton to select the adjustment mode.
2. Touch the [KEY ILLUMI] key to select "RED"
(red) or "GREEN" (green).
3. Touch the [RED] or [GREEN] key to select a
desired mode and set it.
4. Press the [ADJ] button again or touch the
[RTN] key. The unit returns to the previous
mode.
44
VRX938R
Setting the beep
The sound heard when you make operations is
called "beep". The unit can be set up so that it does
not produce this beep sound.
The factory default is "BEEP ON".
1. When the panel is open, press the [ADJ] but-
ton to select the adjustment mode.
2. Touch the [z] key two times to select "BEEP".
Touch the [BEEP] key to select "ON" and "OFF".
3. Touch the [ON] or [OFF] key to select a de-
sired mode and set it.
4. Press the [ADJ] button again or touch the
[RTN] key, The unit returns to the previous
mode.
Setting the sprite pattern speed
The factory default setting is "MID" (mid).
1. When the panel is open, press the [ADJ] but-
ton to select the adjustment mode.
2. Touch the [ANA SENS] key to select "HIGH"
(high) or "MID" (mid) or "LOW" (low).
3. Touch the "HIGH" (high) or "MID" (mid) or
"LOW" (low) key to select a desired mode and
set it.
4. Press the [ADJ] button again or touch the
[RTN] key. The unit returns to the previous
mode.
Advertisement
Table of Contents
