Table of Contents
Advertisement
3.
IMPORTANT NOTES FOR OPERATION
General information
Note: You can switch on with
buttons
or by putting in a cassette.
0-9
* If you have not used the video recorder for a few minutes,
it will switch to standby automatically. For more information,
please read the section 'Automatic switch-off' in chapter
'additional functions'.
* If you have switched the video recorder off with
, the time will show in the display, for instance ,
STANDBY m
'18:00'.
If the clock has not been set, '--:--' will appear.
* When the video recorder is switched off and the time isn't
shown in the video recorder display, the clock display may
be switched off. You will find more information in the
section 'Saving energy'.
* Keep your video recorder connected to the mains at all
times to ensure that programmed recordings can be made
and that the television works normally. Your video recorder
uses less than 4 Watts (with clock-display switched off).
* If the video recorder is not plugged into the mains, it will
usually store TV channels for one year and timer and date
information for three hours.
, the number
STANDBY m
Saving energy
To save energy, you can switch off the clock display on the
video recorder. Programmed (TIMER ) recordings will take
place even if the clock display has been switched off.
1
Switch on the TV set. If required, select the programme
number for the video recorder.
2
Press
on the remote control. The main menu will
MENU
appear.
Select the line 'SPECIAL SETTINGS' with
3
;P+
and confirm with
SPECIAL SETTINGS
OSD
CLOCK DISPLAY
COUNTER
SAT RECORDING
REPEAT PLAY
DIRECT RECORD
________________________________
EXITpMENU
4
To switch off the clock display on the video recorder,
select 'OFF' in line 'CLOCK DISPLAY' with
Note: To switch the clock display on, select 'ON'.
5
Confirm with
.
OK
'STORED' will briefly appear on the TV screen.
6
To end, press
.
MENU
Emergency interrupt
You can use
on the video recorder or the remote
STANDBY m
control to interrupt any function.
So if you are having operating problems, you can just interrupt
the function and start again.
And you can practise operating your set without any worries.
No matter which buttons you press, you cannot damage it.
P- =
.
OK
è ON
p
OFF
T.LEFT
OFF
OFF
OFF
STOREpOK
.
P
or
9
Advertisement
Table of Contents
