Table of Contents
Advertisement
14.
protect yourself from electric shock. Do not use outdoors. Insulate yourself from
the workpiece and ground. Use nonflammable, dry insulating material if possible,
or use dry rubber mats, dry wood or plywood, or other dry insulating material big
enough to cover your full area of contact with the work or ground.
15.
Ensure that the unit is placed on a stable location before use. If this unit falls
while plugged in, severe injury, electric shock, or fire may result.
16.
•
Keep cylinders away from any electrical circuits, including welding circuits.
•
Keep protective cap in place over the valve except when the cylinder is in use.
•
Use only correct gas shielding equipment designed specifically for the type of
welding you will do. Maintain this equipment properly.
•
Always protect gas cylinders from heat, being struck, physical damage, slag,
flames, sparks, and arcs.
•
Always use proper procedures to move cylinders.
Use the right tool for the job. Do not attempt to force small equipment to do the
17.
work of larger industrial equipment. There are certain applications for which this
Welder was designed. It will do the job better and more safely at the rate for which it
was intended. Do not modify this Welder, and do not use this Welder for a purpose
for which it was not intended.
18.
WARnInG! People with pacemakers should consult their physician(s) before
using this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference to or failure of the pacemaker.
WARnInG! The warnings and cautions discussed in this manual cannot cover
19.
all possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
WARnInG! This product, when used for welding and similar applications, pro-
20.
duces chemicals known to the State of California to cause cancer and birth defects
(or other reproductive harm).
(California Health & Safety Code § 25249.5, et seq.)
SKU 95424, 95629
Cylinders can explode when damaged:
•
Never weld on a pressurized or a closed cylinder.
•
Never lay a welding torch on a cylinder.
•
Never allow a welding electrode to touch the cylinder.
sAVE tHEsE InstRUCtIOns
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
Page 9
Advertisement
Table of Contents
