Table of Contents
Advertisement
(See Figure G)
4. Remove the protective cap from the cylinder. Stand to the side of the cylinder valve, and
open the valve slightly to blow dust and dirt from the valve. Then, close the valve. (See
Figure G)
5. Make sure the Flow Adjust on the Pressure Regulator/Flow Meter is turned off. Then,
screw the Pressure Regulator/Flow Meter firmly onto the cylinder valve. (See Figure G)
WARnInG: Using an oversized gas cylinder can cause tipping, result-
6. Attach the Gas Hose from the Pressure Regulator/Flow Meter to the Gas Inlet Valve lo-
ing in cylinder and equipment damage and personal injury. nEVER exceed
cated on the Rear Panel of the Welder. (See Figure G)
maximum cylinder weight of 100 lb.
7. Adjust the flow rate of the gas by turning the Flow Adjust. The typical flow rate is 20 cfh
1.
CAUtIOn! Do not use an Argon/Mixed pressure regulator/flow meter with CO
(cubic feet per hour). Make sure to check the Welding Wire manufacturer's recom-
shielding gas. To use CO
mended flow rate. (See Figure G)
regulator/flow meter (neither one included).
2.
With help, set cylinder (not included) upright against post or other stationary ob-
MIG&ARC 250 AMP - SKU 95424
ject. Use chain or heavy-duty strap (neither included) to secure cylinder in place.
MIG DUAL 250 AMP – SKU
(see figure G.)
3.
Remove the protective cap from the cylinder. Stand to the side of the cylinder
valve, and open the valve slightly to blow dust and dirt from the valve. Then,
close the valve. (see figure G.)
4.
Make sure the Flow Adjust on the Pressure Regulator/Flow Meter is turned off.
Then, screw the Pressure Regulator/Flow Meter (not included) firmly onto the
cylinder valve. (see figure G.)
5.
Attach the Gas Hose for the Pressure Regulator/Flow Meter to the Gas Inlet
Valve located on the Rear Panel of the Welder. (see figure G.)
6.
Adjust the flow rate of the gas by turning the Flow Adjust. The typical flow rate is 20
CFH (cubic feet per hour). Make sure to check the Welding Wire manufacturer's
recommended flow rate.
SKU 95424, 95629
InstALLInG A GAs CyLInDER
2
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
shielding gas, you must install a CO
1.
2.
Remove Cap, stand to side of valve
slightly. Gas flow blows dust and dirt
from valve. Close valve.
3.
4.
Install so face is vertical.
5.
6.
Connect customer supplied gas hose
between regulator/flowmeter hose con-
nection, and fitting of welder.
7.
8.
9.
gas pressure
2
Cap.
Cylinder Valve.
Cylinder.
Regulator/ Flowmeter
Regulator/Flowmeter Gas.
Hose Connection.
Flow Adjust.
Solid post or other stationary object.
Chain or strap.
FIGURE G
Page 20
2
Page 19
Advertisement
Table of Contents
