.
WARNING! Make sure to turn off the Welder and unplug it from its electrical outlet
prior to changing wire settings.
1. Lift the Door (14A) of the Welder to expose the Wire Drive Assembly.
2. Loosen, and lower the Handle (4D) on the Wire Drive Assembly.
3. Remove the Screw that secures the Roller (5D) in place. Then, remove the two Rollers.
1.
WARnInG! Make sure to turn off the Welder and unplug it from its electrical
4. Flip each Roller 180 degrees. (See Figure F)
outlet prior to changing wire settings.
NOTE: The two Rollers are "keyed", meaning they can only be reinstalled one way.
2.
Lift the Door (14A) of the Welder to expose the Wire Feed Assembly.
5. Reinstall the two Rollers, and secure the Rollers in place with the Screw. (See Figure F)
6. Install the Spool of Welding Wire, and route the Wire to the Torch Gun. Then, test and, if
3.
Loosen, and lower the Handle (4D) on the Wire Feed Assembly.
necessary, adjust the Wire Drive Assembly as discussed in the previous pages of this
4.
Remove the Screw that secures the Roller (5D) in place. Then remove the two
manual.
Rollers.
ROLLERS (5D)
5.
Flip each Roller 180 degrees. (see figure f.)
note: The two Rollers are "keyed", which means they can only be reinstalled one
way.
Insert the Connecting Plug of the Ground Cable (22A) into the Terminal Ground (7C) and
6.
Reinstall the two Rollers and secure the Rollers in place with the Screw.
twist the Connecting Plug to lock it in place. (See Part List page 34)
(see figure f.)
.
7.
Install the Spool of Welding Wire and route the Wire to the Torch Gun. Then, test
and, if necessary, adjust the Wire Feed Assembly as discussed in the previous
pages of this manual.
Insert the Connecting Plug of the Electrode Cable (21A) into the Terminal Electrode (6C)
and twist the Connecting Plug to lock it in place. (See Part List page 34)
Insert the Connecting Plug to the Ground Cable (22A) into the Terminal Ground (7C)
and twist the Connecting Plug to lock in place. (See Parts List on Page 31).
MIG&ARC 250 AMP - SKU 95424
MIG DUAL 250 AMP – SKU
AttACHInG tHE ELECtRODE CAbLE (ARC WELDER OnLy)
Insert the Connecting Plug to the Ground Cable (22A) into the Terminal Electrode
(6C) and twist the Connecting Plug to lock in place. (See Parts List on Page 31).
SKU 95424, 95629
CHAnGInG WIRE sEttInGs
WELDING WIRE
TO ATTACH THE GROUND CABLE WITH CLAMP
TO ATTACH THE ELECTRODE CABLE
(Only MIG/ ARC 250 AMP)
AttACHInG tHE GROUnD CAbLE WItH CLAMp
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
FLIP
180° ° ° °
FIGURE F
Page 18
Page 17