Chicago Electric 95424 Assembly And Operating Instructions Manual page 15

3. Loosen, and lower the Handle (4D) on the Wire Drive Assembly. Then, raise the
3. Loosen, and lower the Handle (4D) on the Wire Drive Assembly. Then, raise the
3. Loosen, and lower the Handle (4D) on the Wire Drive Assembly. Then, raise the
Lever (3D). (See Figure B)
Lever (3D). (See Figure B)
Lever (3D). (See Figure B)
4. Keep tension on the Wire, and guide at least 12 inches of Wire into the Wire Inlet
3. 4. Keep tension on the Wire, and guide at least 12 inches of Wire into the Wire Inlet Loosen and lower the Tension Adjusting Knob on the Wire Feed Assembly. Then,
4. Keep tension on the Wire, and guide at least 12 inches of Wire into the Wire Inlet
Guide. (See Figure C)
Guide. (See Figure C)
Guide. (See Figure C) raise the Swing Arm. (see figure b.)
Wire Inlet Guide
Wire Inlet Guide
Wire Inlet Guide
4. Keep tension on the Welding Wire, and guide at least 12 inches of Wire into the
5. Lower the Lever (3D) on the Wire Drive Assembly. Raise and tighten the
5. Lower the Lever (3D) on the Wire Drive Assembly. Raise and tighten the
5. Lower the Lever (3D) on the Wire Drive Assembly. Raise and tighten the
Handle (4D). Once the Wire is held in place, you may release it. (See Figure D)
Wire Feed Leader. (see figure C.)
Handle (4D). Once the Wire is held in place, you may release it. (See Figure D)
Handle (4D). Once the Wire is held in place, you may release it. (See Figure D)
5. Lower the Level on the Wire Drive Assembly. Raise and tighten the Handle. Once
the Wire is held in place, you may release it. (see figure D.)
MIG&ARC 250 AMP - SKU 95424
MIG DUAL 250 AMP – SKU
SKU 95424, 95629
AssEMbLy InstRUCtIOns (COntInUED)
Handle
Handle (4D)
Handle
Lever
Lever (3D)
Lever
Handle
Handle (4D)
Handle
Lever
Lever (3D)
Lever
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
FIGURE B
FIGURE B
FIGURE B
Welding Wire
Welding Wire
Welding Wire
FIGURE C
FIGURE C
FIGURE C
Welding Wire
Welding Wire
Welding Wire
FIGURE D
FIGURE D
FIGURE D
Page 16
Page 15