Table of Contents
Advertisement
7.
If using solid-core wire, connect and secure an Argon/ CO
the Welder. (If using flux core wire, protective gas is not required.)
POWER SWITCH (1C)
WIRE FEED
SPEED KNOB (3C)
ELECTRODE
WELDING
INDICATOR (4C)
8.
Set the desired welding voltage and wire speed for the thickness of metal being
welded, using the Voltage Selector Knob (5C) and Wire Feed Speed Knob (3C).
9.
Make sure the Power Switch (1C) is in its "OFF" position. Then plug Power Cord (1A)
(see figures K & j.)
of the Welder into a dedicated, 230 VAC, 40 AMP line with delayed action type circuit
breaker or fuse. (See page 32.)
9.
While holding the Welding Gun (20A), with the Welding Wire clearly out of the way
10. While holding the Welding Torch (10C), with the Welding Wire clearly out of the way of
of any grounded objects, turn the Power Switch (1C) to its "On" position.
any grounded objects, turn the Power Switch (1C) to its "ON" position.(See Figure G)
(see figure K.)
11. Momentarily squeeze the Trigger Switch (13E) of the to test the wire feed speed. If
necessary, adjust the speed by turning the Wire Feed Speed Knob (3C).
10.
Momentarily squeeze the Trigger (13E) of the Welding Torch to test the wire feed
(See Figure G)
speed. If necessary, adjust the speed by turning the Wire Speed Control Knob
12. Orient yourself on the area to be welded, then place a Face Shield over your eyes.
(3C). (see figure K.)
11.
Orient yourself on the area to be welded, then place a Face Shield over your eyes.
ARC (stICK) WELDInG sEt Up (fOR MODEL 95424 OnLy)
12.
Turn the Wire feed speed Knob (3C) to the appropriate sector. The RED
For switching in ARC mode Wire Feed Speed Knob (3C) in appropriate sector. Red
13.
Electrode Indicator (4C) will light up and the wire will not move. (see figure
ELECTRODE WELDING INDICATOR (4C) will light up. (See Figure G)
K.) Below are recommended positions of the Voltage selector Knob (5C.)
14.
NOTE: Welder MIG DUAL 250 AMP has no about the WIRE FEED SPEED KNOB
(3C) sector "Electrode" and ELECTRODE WELDING INDICATOR (4C)
SKU 95424, 95629
MIG WELDInG sEt Up
WARNING! Never look at the ignited arc without ANSI-approved, arc-
shaded, eye protection in a full face shield. Permanent eye damage
or blindness can occur. Skin burns can occur. Never breathe arc
fumes.
Diameter of electrode
1/16"
1/8"
3/16"
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
gas hose to the rear of
2
OVERLOAD PROTECTOR (2C)
VOLTAGE SELEC-
TOR KNOB (5C)
Voltage Selector Knob position
1-4
3-6
5-8
FIGURE K
Page 22
Advertisement
Table of Contents
