Input Switching; Size Switching - Hitachi PW2 42PD7A10A User Manual

OPERATING INSTRUCTIONS (continued)
CHANNEL UP/DOWN buttons

Input Switching

• Input can be switched by pressing the AV1~6, RGB1 or
RGB2 buttons of the remote control.
• Input can be switched to TV by pressing CHANNEL
UP/DOWN buttons or PROGRAM SELECT buttons.
• Input can be switched in the sequence of TV
AV2 ➝ AV3 ➝ AV4 ➝ AV5 ➝ AV6 ➝ RGB1 ➝ RGB2 by
pressing the INPUT SELECT button of the control panel.
TV AV1
RGB2 RGB1

Size Switching

Each time the ZOOM button of the remote control is
pressed, the screen display size will change in sequence
and the status will be displayed at the bottom of the screen.
• During TV/VIDEO signal input (AV4, AV5, AV6, RGB1
(set to [DVI-STB]) and RGB2 (set to [Component]))
Panoramic
14:9Zoom C14:9L
• The size will fix as Full mode and not change when receiving the
component signal of 1080i/50, 1080i/60, 720p/50 or 720p/60.
Full
Display size selection diagram
When you want to
Play a 4:3 image in a 16:9 screen faithfully.
Play a 4:3 image in a 16:9 screen with the
height and width of the middle of the
screen enlarged on equal scales and with
both sides appearing somewhat enlarged.
Play a 16:9 VISTA size image in the 4:3
image faithfully reproduced on the 16:9
screen.
Play a 4:3 image faithfully in a 16:9 screen
in the standard vertical size and horizontal-
ly squeezed.*
22
INPUT SELECT button
➝ AV1 ➝
AV2 AV3 AV4
AV6 AV5
4:3 Full
Zoom
Set the display size to
4 : 3
Panoramic
Zoom
Full
INPUT SELECT
buttons
ZOOM button
• During AV1~ AV3 signal input
Auto
14:9Zoom
• [Auto] is the mode using the Switch signal from the equipment
connected to AV1~AV3 terminal included in SCART connector
No.8 pin which indicate the picture format of the video source.
When Switch signal has not been detected, Default Zoom setting
in the Function Menu is used to choose.
• During TV mode
Auto
14:9Zoom
• [Auto] is the mode using WSS (Wide Screen Signals) which
identify the picture format movies and programs are broadcast in.
Various broadcast stations now transmit WSS. It can be detected
and the monitor automatically switch to the correct format.
However, some broadcasters do not transmit WSS, so this monitor
will not recognize which format is being transmitted. Therefore,
Default Zoom setting in the Function Menu is used to choose when
a WSS has not been sent or has not been detected.
Input signal Display screen
(4:3 signal)
(Vista)
(Squeeze)
RECALL button
CHANNEL
UP/DOWN button
PROGRAM
SELECT buttons
Full Zoom
C14:9L
Full Zoom
C14:9L
Remarks
Blanking occurs on both sides.
• The 4:3 image is called a letterbox image.
• In some cases, some slight blanking may
remain at the top and bottom.
* An image with an aspect ratio of 16:9 shrunk
horizontally to 4:3 to display in a 4:3 screen.