Fixing Plate For The Magnet - Duerkopp Adler 910 Service Instructions Manual

5.6 Fixing plate for the magnet

6 5 4 3 2 1
Caution: danger of injury!
Turn off the main switch.
Check and adjust fixing plate only when the sewing unit is switched off.
Note and control
When the thread trimmer is in the resting position, the latch 2 should
snap unhindered into the cutout 3 of the fixing plate 5.
There should be as little clearance as possible between the latch 2 and
the cutout 3.
–
Press the magnet shaft 4 to the left.
–
Turn the handwheel until the roller bolts 7 grip on the cam disc 8.
–
Turn the handwheel further until the cutting process is ended.
–
Check the position of latch 2.
Adjustment
–
Loosen screws 1 and 6.
–
Adjust fixing plate 5 accordingly.
–
Tighten screws 1 and 6.
–
Proceed with the cutting process.
–
Check the position of latch 2.
8
7
3
5
2
3
33