Thread Trimmer; Thread Trimmer Magnet - Duerkopp Adler 910 Service Instructions Manual

5.

Thread trimmer

5.1 Thread trimmer magnet

4 3 2 1
Caution: danger of injury!
Turn off the main switch.
Check and adjust thread trimmer magnet only when the
sewing unit is switched off.
Note and control
The magnet 3 pushes the lever 5 with the roller bolt into the
thread trimmer cam 6 by means of lever 1.
When the roller bolt is pushed in, it must have some axial clearance
in the cam.
Push magnet shaft 3 to the left into the magnet, and verify that there is
some clearance between the roller bolt and the thread trimmer cam.
Adjustment
–
Loosen screws 4.
–
Press together magnet shaft 2 and magnet 3.
–
Then shift the magnet to the left as far as it will go.
–
Move magnet back minimally.
–
Tighten screws 4.
–
Check whether there is some clearance between the roller bolt and
the thread trimmer cam when the roller bolt is pushed in.
6 5
3
27