Troubleshooting; Initialization Check; Check Performance By Self-Check Function; Indicator Led - Epson LX-300 Service Manual

EPSON LX-300+

3.2 Troubleshooting

3.2.1 Initialization Check

Before troubleshooting, check the following basic items.
1. When printer can perform printing, perform self-test and check if any
troubles occur.
2. When the printer cannot perform any printing, check the setting by
"Default Setting". (Refer to Chapter 1.)
3. Check if the outside and inside the printer is noticeably dirty or if any
parts are broken. If there is dirt, perform cleaning referring to Chapter 6
"Maintenance".
4. Make sure each harness is connected properly.
5. Make sure no remarkable friction among printer mechanism gears. Make
sure all gears are linked properly.
6. Make sure there is no dirt nor scratch on rollers inside the printer.
7. Perform EEPROM clear as needed. Inside setting is reset to the factory
default setting. (Refer to Chapter 1.)
Troubleshooting

3.2.2 Check Performance By Self-Check Function

LX-300+ has self-check function and it supervises the printer condition
constantly. If any problem occurs, it indicates error by indicator LED and in
some cases it notifies error to the operator by beeping the buzzer. Identify
error cause, referring to the indication first. If error is not solved, perform unit
repair.

3.2.2.1 Indicator LED

The table below shows the indicator LED and the printer condition.
Printer Condition
Pause
Paper Out Error
Release Lever Error
Paper Eject Warning
MICRO Adjust
Tear Off
Font Select
Fatal Error
Paper Out Error
This error will be indicated when printer fails to feed paper or paper is
run out.
Solution
Set paper properly and try paper feed again.
Troubleshooting
Table 3-1. Indicator LED
Pause Paper Out Front
ON - -
ON ON -
ON - -
ON BLINK -
BLINK - -
According to
- - LED On/Off
combination
According to
- - LED On/Off
combination
BLINK BLINK BLINK
Revision A
Buzzer
-
Shoot beep x3
Long beep x5
-
-
-
-
-
57