Print Position Adjustment - Epson H5200 - TM B/W Thermal Line Service Manual

4.1 ADJUSTMENT
This section describes the adjustment procedure for the EPL-5000/5200 and ActionLaser 1000/1500.
This adjustment must be performed after every servicing operation, especially when any
component or part is replaced.

4.1.1 Print Position Adjustment

You can adjust the vertical print position on a sheet of paper by turning the image synchronizing
volume control on the engine controller board (PWB-A). After the engine driver board (PWB-A) is
replaced, be sure to adjust the print position following the procedure below.
1. Set LANGUAGE to ENGLISH in SelecType Level 2.
2. Run a FEATURE PRINT in SelecType Level 2.
registration gap between the leading edge of paper and the printing of a horizontal line is not
the following value:
FEATURE PRINT page for EPL-5200and ActionLaser 1500: 35.8* 2.5 mm (1.41 * 0.10 inch)
The FEATURE PRINTpage contains the model name on the upperlefi side. Check the
Note:
model name on the FBTURE PRINT page before adjusting. lhe position of the
horizontal line is diffenmt for the EPL-500WActionLaser 1000 than for the EPL-5200/
I
I
Tumtheprinter power off.
3.
panel.
Figure 4-2. Opening the Upper Unit, Upper Cover and
Rev. B
Leading Edge
I
FEATURE PRINTSH=
Figure 4-1. Print Position Adjustment
Removing 1 Screw
Perform the following procedure if the
24.7 +/- 2.5 mm (1.37+/- O.10hch)
a
35.8 %25 mm (1.41 +/- O.10in&)
/
Adjustment