Volume Control - Fusion MS-IP700 Instruction Manual

Important: If a Zone is disabled, you cannot change any of the following
settings for that Zone.

Volume control

Zones 3 and 4 can have volume control disabled. You should disable volume
control for a Zone that has its volume controlled from another amplifier or
Head unit. If volume control is:
• Enabled: turning the Encoder will change line level output for the
selected Zone only.
• Disabled: turning the Encoder will not change line level output for the
selected Zone.
To enable or disable volume control:
a. Select the Volume Control menu item.
b. Press the Encoder to enable ( ) or disable ( ) volume control.
c. Press any key to exit
Link to zone 1
Zones 1 and 2 can be linked so that any volume or sub-woofer level changes
are applied to both Zones. A small "+" sign is displayed on screen between
Zones 1 and 2 when this feature is enabled.
To link Zone 2 level to Zone 1 level:
a. Select the Link to zone 1 menu item.
b. Press the Encoder to link the two Zones ( ) or unlink ( ) the Zones.
c. Press any key to exit
Balance
To specify the balance for the selected Zone:
a. Select the Balance menu item.
b. Turn the Encoder to the left or right to adjust the Balance for the selected Zone.
c. Press any key to exit
41