Switching The Sound Adjustment Mode; Parametric Equalizer Adjustment (Peq); Setting A Preset Eq; Adjusting Center Frequencies And Q Curves - Eclipse CD5100 Owner's Manual

Various Settings
Switching the Sound
Adjustment Mode
Press the [CUSTOM/MENU] button
1
for more than one second.
The Menu Selection mode is activated.
Press the [SELECT] (Upper/Lower)
2
button to select the SOUND.
3
Press the [ENTER] button.
The sound
activated.
Press the [SELECT] (Upper/Lower)
4
button to select the setting item.
When the button is pressed, the
setting item changes as follows.
PEQ ↔ Position selector ↔ Cross over
↔ Non-fader phase ↔ PEQ ↔
5
Press the [ENTER] button.
Switches among
modes.
ATTENTION
If returning to previous screen, press the [RTN]
button.
Parametric equalizer
adjustment (PEQ)
Press the [SELECT] (Upper/Lower)
1
button to select the PEQ.
2
Press the [ENTER] button.
The PEQ setting mode is activated.
48
adjustment mode
the adjustment

Setting a preset EQ

Select any button, from [2] to [6],
1
and press it when PEQ setting
mode is activated.
Any of the preset buttons is pressed,
the preset EQ mode changes as
follows.
Button
[2]
is
[3]
[4]
[5]
[6]
ATTENTION
When BASS, MIDDLE and TREBLE values
are adjusted in audio control mode, CUSTOM
EQ will be updated. (Refer to page 44 for
details on audio control operation.)
Adjusting center frequencies and Q
curves
The three bands, Bass, Middle and Treble can be
adjusted and each band has frequency level and
Q curve to be adjusted. Narrow, Normal,
MidWide and Wide can be adjusted for Bass,
Normal and Narrow for Middle, and Normal for
Treble.
Press the [ENTER] button to select
1
the band to be adjusted.
Each time the button is pressed, the
band changes in the following order.
BASS → MIDDLE → TREBLE →
Mode Description
DEFEAT FLAT
Low frequencies
POWER
emphasized
High frequencies
SHARP
emphasized
Mid frequencies
VOCAL
emphasized
Equalizer user
CUSTOM
preset value