Logging On To The Client; Functions In The Web User Interface - Lenovo ThinkCentre M90p Configuration Manual

Note: You can refer to detailed configuration examples for both manual setup and

Logging on to the client

The client can be accessed from a management console on the network that has a
supported Web browser.
1. Open a Web browser on the management console and type one of the following
2. Click Log On in the Intel Active Management Technology window.
3. In the Enter Network Password window, enter your username and password

Functions in the Web user interface

The Web user interface enables you to perform the following tasks:
v View the system status
v View the hardware information of your AMT computer, including system,
v View, start, stop, and clear event logs
v Remote power control, including: turn the computer off, cycle power off and on,
v View and manage the Intel AMT power policies
v View and manage the Intel AMT network settings
v View and manage the Intel AMT IPv6 network settings
v View and manage the Intel AMT system name settings
v View and manage the Intel AMT user accounts
24
ThinkCentre M90p with Intel AMT Configuration Guide
configuration mode and automatic setup and configuration mode in
Appendix A, "Examples of configuring Intel AMT in manual and automatic
setup and configuration modes," on page 25.
in the address box:
v For manual setup and configuration mode:
http://IP_Address:16992 (for example, http://192.168.1.13:16992)
v For automatic setup and configuration mode (for TLS):
https://IP_Address:16993 (for example, https://192.168.1.13:16993)
and then click OK. You will go to the client Web user interface.
processor, memory, and hard disk drive
reset, normal startup, start the computer from a local optical drive, and start the
computer from a local hard disk drive