Lenovo ThinkCentre M90p Configuration Manual page 21

Intel(R) ME Network Name Settings: In the INTEL(R) NETWORK SETUP
window, select Intel(R) ME Network Name Settings and press Enter. The
following options will be displayed.
Option
Host Name Enables you to set a host name for your Intel AMT computer.
Enables you to set a domain name for your Intel AMT computer.
Domain Name
Shared/ Enables you to specify whether the Fully Qualified Domain Name
Dedicated (FQDN) is a dedicated domain name for Intel AMT or shared by both
FQDN Intel AMT and your operating system.
Dynamic DNS Used to enable or disable the Dynamic DNS (Domain Name Server)
Update Update Client in the firmware. When the Dynamic DNS Update feature
is set to ENABLED, the firmware will automatically register its IP
address and FQDN on the DNS using the Dynamic DNS Update
protocol.
Note: Set the host name and domain name before you enable the
Dynamic DNS Update feature.
Enables you to set the interval between every two successional updates
Periodic Update
Interval that the Dynamic DNS Update Client in the firmware sends to the DNS.
Notes:
1. The Periodic Update Interval option is only available when the
Dynamic DNS Update feature is enabled.
2. The interval unit is minute. The interval value should be zero or no
smaller than 20. By setting the interval value to zero, you disable the
periodic update feature.
TTL Enables you to set the Time To Live (TTL) value in seconds.
Notes:
1. The TTL option is only available when the Dynamic DNS Update
feature is enabled.
2. The TTL value should be greater than zero. If the TTL value is set to
zero, the firmware will use the default value, which is 900 seconds.
TCP/IP Settings: Select TCP/IP Settings and press Enter. The TCP/IP SETTINGS
window opens. The following options will be displayed:
v "Wired LAN IPV4 Configuration"
v "Wired LAN IPV6 Configuration" on page 14
Wired LAN IPV4 Configuration: Select Wired LAN IPV4 Configuration → DHCP
Mode. The DHCP Mode option is used to enable or disable DHCP mode. With
DHCP mode enabled, the TCP/IP settings will be configured by a DHCP server.
With DHCP mode disabled, the options in the following table will be displayed.
You will be required to configure the static TCP/IP settings for the Intel AMT
computer. If the system is in static mode, a second IP address is required. This
second IP address is often called the Intel ME IP address and is different from the
host IP address.
Option
IPV4 Address Enables you to enter the Intel ME IP address for your Intel AMT
computer.
Subnet Mask Enables you to enter the subnet mask address for your Intel AMT
Address computer.
Chapter 5. Intel AMT setup and configuration on Lenovo ThinkCentre M90p desktop computers
Description
Description
13