Using The Ac Adaptor; Installation; Removal - Panasonic AG-HPD24PJ Operating Instructions Manual

Installation

1
Plug the AC adaptor's AC power supply
cable into the adaptor, and then into a
power outlet.
Connect the AC power supply cable in A-B
order.
2
Slide in the DC power supply cable plate
until it clicks into place.

Removal

POWER lamp
1
Hold the POWER button for two seconds to
turn the power off, and confirm that the
POWER lamp is off.
2
Press the battery lock release button and
slide out the DC power supply cable plate.
◆ NOTE:
• Always be sure that the unit is turned off before
removing the DC cord connector plate.
26
Power Preparations: Using the AC adaptor

Using the AC adaptor

1
Insert the
plugs all the
way in.
3
Unplug the adaptor's AC power supply
cable from the wall outlet.
◆ NOTE:
• The AC Adaptor is designed to operate on
world-wide mains voltages (100 to 240 V)
and frequencies (50/60 Hz). However,
power outlet configurations differ in
different countries. Use a plug that is
designed for the country of operation. If
necessary, contact your supplier to obtain
the appropriate plug adaptor.
• When not using the unit, unplug the
adaptor's AC power supply cable from the
wall outlet.
• The power lamp on the AC adaptor
normally remains lit for a while after it is
unplugged from the wall outlet.
B
A