Panasonic AG-HPD24PJ Operating Instructions Manual page 148

Display of warning information for unit status
When there is a problem with unit status, a warning error "E-**" appears in the OSD display. Press the DIAG button to get
detailed error information.
Display
No Character code
75 STORAGE INTERMITTENT
93 INVALID TC MODE
95 INVALID EMBEDDED TC
96 INVALID TC SEQUENCE
97 NO ACTIVE FRAME
26 CARD ERROR< >
21 REC WARNING
50 BATTERY EMPTY
1
*
After charging the battery, be sure to set the internal calendar and clock.
2
*
Recording is initially accepted after which operation is cancelled and recording is not possible.
Displayed for 3 seconds when reduced storage device performance or other cause
has resulted in a dropout during clip playback.
Use a storage device with higher specifications.
Appears during playback when the time code has been recorded in drop frame
mode. The video output is distorted and audio output is muted at the drop point of
the time code. Check the playback clip.
Playing back a 24p frame-rate clip requires that the time code be recorded in non-
drop frame mode.
Appears when the time code in an HD SDI input is in the drop frame mode during EE
or recording. Normal recording will not be possible under these conditions.
Check signal input to the unit. Set the input time code to non-drop frame mode.
(Appears when menu SETUP - SYSTEM - FREQUENCY is set to 23.98 Hz, 24 Hz, 59-
23 or 60-24.)
Displayed when the time code does not advance at 1x speed when recorded video
frames are synchronized with HD SDI input. (Displayed when the SETUP - SYSTEM
- FREQUENCY menu setting is 59-23 or 60-24.)
Appears during playback when frame rate data in user bits cannot be detected or
when the playback time code is not continuous. The video output is distorted and
audio output is muted in sections where the time code is not continuous. Check the
playback clip.
Appears during EE or recording when frame rate data cannot be detected in the user
bits data in an HD SDI input or when the input time code is not continuous. Normal
recording will not be possible under these conditions.
Check signal input to the unit. Input signals with a matching time code and pull-down
sequence.
(Appears when menu SETUP - SYSTEM - FREQUENCY is set to 23.98 Hz, 24 Hz, 59-
23 or 60-24.)
Appears when active frame data cannot be detected in the user bits in the HD SDI
input during EE or recording. Normal recording will not be possible under these
conditions.
Check signal input to the unit. The input signal must contain the active frame data
from a variable frame-rate camera.
(Appears when menu SETUP - SYSTEM - FREQUENCY is set to 59 - 23 or 60-24 and
VFR REC is set to ON.)
Displayed when data was corrupted due to a P2 card error.
If generated during recording, the message will stay on after recording is stopped
until another operation takes place. (
occurred.)
Replace the P2 card in the slot where the error occurred.
Displayed when a video or audio error occurs during recording.
To continue operation, turn the power off and then back on again.
Corruption of an input signal during recording may terminate recording. Check
signal input to the unit.
Displayed when a drop in the backup battery voltage for the internal clock is
1
*
detected at power on.
Connect an AC adaptor and let the battery recharge for about 4 hours.
For Long and Trouble-Free Operation: Warning and Error Messages
Description
indicates the slot number where the error
Deck operation
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Recording is
* 2
disabled
Operation
continues during
recording
STOP
STOP during
recording,
Operation
continues during
recording pause
due to corrupted
input signals
Operation
continues
85