Epson 3800 - Stylus Pro Color Inkjet Printer Service Manual page 227

EPSON Stylus Pro 3800/3800C/3850
27. Click [OK] and follow the instructions (following procedure) displayed on the
screen to perform color measuring.
1. Set the calibrator with its measuring part matched with measuring start
position (gray part) as shown in
2. Press the button on the side of the calibrator.
3. When it beeps, keep holding down the button and scan the patch along the
scanning ruler to measuring end position (gray part).
4. Once the measuring is completed, release the button.
5. Repeat Step 1 through 4 twice for the same patch line.
6. Repeat Step 1 through 5 to measure the bottommost line to the top line. (The
line which needs to be measured is displayed on the screen.)
28. Once all the lines (5 lines) are measured, click [OK].
29. Measure Sheet 2 by following Step 25
Figure 5-52. Color Measuring Order
ADJUSTMENT
Figure 5-53.
through Step 27.
Start position in the color measuring
Figure 5-53. Setting the Calibrator/Color Measuring Position
Standard Adjustment
End position in the color measuring
Figure 5-54. Color Measuring Screen
Revision A
227