Epson 3800 - Stylus Pro Color Inkjet Printer Service Manual page 225

EPSON Stylus Pro 3800/3800C/3850
18. Load an A4-sized EPSON Enhanced (Archival) Matte paper vertically on the
ASF, and click [Next] to print the first page (Sheet1) of the verify chart.
Never touch the printed calibration chart.
19. When the first page of the verify chart is printed to the last, load another A4-sized
EPSON Enhanced (Archival) Matte paper vertically on the ASF, and click [Next]
to print the second page (Sheet2) of the verify chart.
20. Make sure that there is no missing dot in the verify chart.
If there is any defect, click [Print Verify Chart Again]. The verify chart will be
printed again after performing cleaning.
If there are no missing dots, let the chart stand for five minutes until it dries out
paying attention not to touch the chart
21. When the verify chart dries out (after five minutes), click [Next].
22. Connect the calibrator to the computer, and click [Color Measuring...].
23. Place the calibrator on the calibration base plate, and click [Calibrate].
24. Hold down the button on the side of the calibrator until it beeps. Do not move or
lift the calibrator during pressing the button.
When the calibration is completed normally, the following screen appears.
ADJUSTMENT Standard Adjustment
Figure 5-49. Screen Transition
Revision A
225