Hardware Description - ViewSat VSPRO User Manual

HARDWARE DESCRIPTION

HARDWARE DESCRIPTION HARDWARE DESCRIPTION HARDWARE DESCRIPTION
2. HARDWARE DESCRIPTION
2.1. FRONT PANEL
1) POWER: This key is used to turn the receiver on and off (stand by).
2) CH : These keys are used to change the channels.
3) VOL : These keys are used to increase and decrease the volume level manually.
4) MENU : This key is used to open up the menu.
5) OK : This key is used to enter and confirm any data to the receiver in the menu
systems.
6) INFRARED SENSOR : This is to receive the IR commands from the RCU. Do not
block the view of the sensor.
7) DISPLAY : This display will show the current channel number(* Channel name) .
While the receiver is in standby mode, the display will show the current time.
(* available for VFD model only )
8) USB HOST PORT: This is used to connect your USB Device to your receiver.
(Either front side USB port or rear side must be selected in the menu.)
7
2.2. REAR PANEL
1) DISH IN: This port is to connect the coaxial cable from LNB of your Dish. The IF input
is provided through this port and the input frequency range is 950~2150MHz.
voltage switching 13V and 18V is passed through this port.
2) LOOP OUT: To enable the connection of an analog receiver, the receiver is provided
with this port. Connect this port to LNB IN port of the other receiver via RF Cable.
3) SERIAL PORT: Connect your receiver to a computer with a serial cable. This port
can be used for upgrading software.
4) USB HOST PORT: This is used to connect your USB Device to your receiver.
(Either front side USB port or rear side must be selected in the menu.)
5) S-VIDEO: Connect to your TV with a S-Video cable.
6) S/PDIF DIGITAL OUTPUT: This port is for the connection to the external Hi-Fi
system which has an optical S/PDIF input interface (Option).
7) IN FROM ANT/CATV : Connect your RF channels to your TV through Loop (Option).
8) CH 3, 4 : The switch select RF 3, 4 channel number.
9) OUT TO TV: Connect to your TV with RF cable (Option).
10) VIDEO, AUDIO R/L, COMPONENT(Y, Pb, Pr): These RCA connectors are used to
connect any external video and audio.
11) POWER INPUT: This is the AC main power cord. The input AC volts range is 95V to
240V, 50Hz/60Hz supply.
12) POWER SWITCH: This is a switch to turn on and off the AC main power.
Also, the
8