Installation - ViewSat VSPRO User Manual

7.2. INSTALLATION

After setting up all parameters, push Red key to go to next step.
Refer to the following description for each parameter.
※
17
.
Installation menu helps you to setup a
variety of parameters necessary for receiving
signal, and reset the channel data, etc.
When you select each submenu in
Installation menu you may be asked to enter
your PIN code.
You can use submenus by entering it.
Push the MENU key to save it and return to
previous menu.
7.2.1. Select Satellite
Select Select Satellite menu in Installation
menu.
Your receiver is provided with
preprogrammed information of transponders
for various satellites.
Select desired satellites to activate by using
the up/down keys ( ) and OK key.
▲ · ▼
To deactivate satellites, push OK key again
on the selected satellite.
* Blue : Add new name of satellite
7.2.2. Antenna Setting
Select Antenna Setting menu in Installation
menu.
Adjust the parameter at each submenu by
using the up/down ( ) and the left/right
▲ · ▼
keys( ) with checking the Quality and
◀ ∙ ▶
Signal strength.
When OK icon available, push the OK key
※
to open the option list.
Satellite : Select a Satellite to setup
LNB Frequency : Select a LNB Frequency.
22 KHz Tone : Turn on or off the 22KHz Tone out.
DiSEqC 1.0 & : Using DiSEqC 1.0 or 1.1 select a port number. Otherwise, select
DiSEqC 1.1 None
: Select either 1.2 / USALS / Disable
Motor Type
7.2.3. Channel Search
Select Channel Search menu in Installation.
Adjust the parameters at each sub menu by
using the up/down (
keys(
Signal strength.
After setting up all parameters, push Red key
to start searching channels
Caution: In case Signal and Quality bar is
※
colored in Grey, check the antenna
connection and parameters.
*Blue: Start Blind Scan
: Blind Scan search the channel when you don't know the transponder information. That
scan procedure may take a few minutes.
Mode : Auto – All TPs to be searched (recommended).
Manual – A specific TP to be searched.
Network Search : Setting this on, unknown or new TPs to be searched.
Search Type : Select kinds of channels to be searched.
Move Motor : drive your motor with checking the signal strength.
) and the left/right
▲ · ▼
) with checking the Quality and
◀ ∙ ▶
18