ViewSat VSPRO User Manual page 11

19
The channel searching process takes a few
minutes.
It shows the searched TV channels on the
left and Radio channels on the right.
When the Progress bar reaches 100%,
searching process is done.
Push OK key to save and exit.
Tip : Exit key finishes searching anytime
※
with saving channel info searched by that
time.
7.2.4. LNB Power
Select LNB Power menu in Installation
menu.
Set LNB Power ON or OFF
(Available only for Splitter LNB)
7.2.5. Motor Setting
Select Motor Setting menu in Installation
menu.
If you have a DiSEqC 1.2 or USALS
motorized system, then you can take
advantage of the Motor control function.
You can drive your motor by using this
menu. Adjust antenna direction using the
left/right keys( ) with checking the
◀ ∙ ▶
signal strength.
Move Motor : Move to East or West direction while pushing the left or right key.
Recalculation : Apply the calibrated value to all Satellites.
East / West limit : Set the limit position.
Save current limit : Store the current position of the motor for the selected satellite.
Remove current limits : Remove the previous limit information.
Motor central position : Move to center.
1.3(USALS) only
My Longitude : Input a value of longitude by numeric keys and set West or East by
the left/right keys( ·
◀ ▶
My Latitude : Input a value of longitude by numeric keys and set West or East by
the left/right keys( ·
◀ ▶
Goto the Position : Move the motor to the position as the input value.
7.2.6. Edit TP List
Select Edit TP List menu in Installation
menu.
You can select a satellite and edit the TP of
that.
Select a TP by using the up/down keys
(
Edit the TP data by using numeric keys.
* Green: Add New TP
*
satellite.
) .
) .
) and push OK key.
▲ · ▼
key will pop up a menu for selecting
7.2.7. Update Software
You can upload your software and
channel data from Receiver to PC or
USB memory through a serial cable or a
USB cable.
Please contact the distributor. They will
provide you with useful information about
this.
20