Menu Operation; Installation - ViewSat 9000HD User Manual

MENU OPERATION

MENU OPERATION
MENU OPERATION MENU OPERATION
7. MENU OPERATION
The main menu is classified into several sub menus which will carry out the
various operation individually.
MAIN MENU
After installing your dish system and receiver with appropriate connectors, plug in
the AC main power and turn on the receiver.
Favorites"menu and "Installation"menu. The default factory PIN code is "0000".
Press the "menu"key or "exit"key to return to previous menu.

1. INSTALLATION

15
Press the MENU key of the RCU. You
will see the "Main Menu"on the TV
screen as follow.
Please note that the "Common
Interface"menu will be displayed for the
CI Model.
You can move into the desired submenu
using the "up/down"keys(▲·▼) or
numeric keys.
Press "OK"key to confirm your selection.
If the "Main Menu"is locked, note that
you should enter the PIN code in order
to move into the corresponding submenu
in case of "Edit Channels"menu,"Edit
"Installation"menu helps you to
setup a variety of parameters
necessary for receiving signal, add
new service, upgrade the new
software and reset the channel
data.
Select "Installation"menu in main
menu, and you will be asked to
enter your PIN code.
You can find the following
"Installation"screen by entering it.
1.A. ANTENNA SETUP
Your receiver includes the preprogrammed information of transponders contained in
various satellites.
You can update the transponder list preprogrammed for a satellite by adding a new
transponder to it or modifying the information of the existing transponder. (Refer to the
Channel Scan described in section 1.B)
Select
I nstallation
"
will be displayed.
Select the desired satellite using the
l eft/right
"
Type
1.0
left/right keys(
LNB Power : Depending on the user s antenna LNB, you can supply either
'
LNB power by setting
"
set this to O N .
" "
LNB Type : You can select the LNB type.
: You can select the predefined LNB frequency or manually
LNB Freq.
enter a specific frequency in MHz unit by pressing numeric
keys.
: In case you are using two antennas connected to a 22KHz
22KHz
tone switch box, you can supply either 22KHz by setting
O N o r off by setting O FF
" " "
DiSEqC 1.0 : If you have DiSEqC box, you can choose port by selecting port
number. Otherwise, choose
: If you have a DiSEqC 1.2 motorised system, then you can take
Motor
advantage of the DiSEqC 1.2 functions available. Choose
Installer as Motor and press "OK" key.
After that, adjust antenna direction using browse keys.
A ntenna Setup m enu in
" "
m enu and the following screen
"
keys( ) . Set L NB Power , L NB
" ◀ . ▶ " " "
, L NB Freq , 2 2KHz , and D iSEqC
" " " " " "
f ields to the appropriate value using the
"
) at each field.
◀ . ▶
O N o r not by setting O FF . Normally
" " "
t o select antenna.
"
n one
" " .
16