Advertisement
Auto loading is a function to facilitate replacement of the prin ting paper.
It is enabled by setting the function selection terminal(Gate Array Pin 38) to "LOW."
Functioning:
1)
Make the PE sensor detect PE once.
2)
Insert the printing paper into the printing paper insertion slot until the PE sensor detects the paper
again.
When this is done, the paper should be inserted at a right angle to the insertion slot; insert it
until it comes to the end.
3)
When this is done, if the head-up lever is shifted down, auto loading will be performed.
head-up lever is shifted up, shift it down.
4)
See Table 5.1 for the drive speed.
Then, auto loading will be performed.
35
CBM-202PC-04 User's Manual
CITIZEN
If the
Advertisement
