Advertisement
The printer has two kinds of error outputs. (Up to a current of 10mA is available in order to mainly indicate
with the LEDs.
If this limit is exceeded, the CPU may be destroyed.
LEDs, etc. carefully.)
LEDPE(Pin 4) of the CPU is a paper error exclusive output.
out, and "HIGH" is output when new printing paper is set.
in the following patterns.
1) Error output pattern
Error
Memory error
Cutter lock
(Cutter error)
Head-up
VH voltage error
Head temperature
error
Macro execution wait
2) Error descriptions
Error
Head-up
VH voltage error
Head temperature error
Cutter lock
(ASC-220-5V)
Note)
The upper-limit voltage of 8.5V for the VH voltage error is a voltage assumed only immediately after
charging the battery when the battery power is used and cannot be normally used.
normal voltage is 7.2V.
Display Pattern
The head-up lever has been shifted up.
When the VH voltage is beyond an allowable range (4.2 ~ 8.5V)
When a head temperature is less than 0°C or 65°C or more
When the cutter is locked due to an external factor (Paper jam, etc.) at cutter
drive time
25
CBM-202PC-04 User's Manual
Select the current control resistors,
"LOW" is output when the printing pap er runs
LEDER(Pin 3) of the CPU outputs other errors
Description
Blinks at intervals of 200 ms
Blinks at intervals of 150 ms(6 times) and 500
ms(1 time) as one cycle.
Illuminated until the error is reset.
Illuminated until the error is reset.
Blinks at intervals of 1 sec.
Blinks at intervals of 500 ms
Description
A maximum
CITIZEN
Advertisement
