Advertisement
3) Resetting methods
Error
No-paper
Head-up
VH voltage error
Head temperature error
Cutter lock(ACS-220-5v)
Note)
1.
If auto loading has not been selected with the function selection J4(Jumper), set the paper manually.
If it has been selected, the auto loading function will be enabled to facilitate paper replacement.
2.
The upper-limit voltage of 8.5V for the VH voltage error is a voltage assumed only immediately after
charging the battery when the battery power is used and cannot be normally used.
normal voltage is 7.2V.
Set the paper.
See Note 1.
Shift down the head-up lever.
Set the VH voltage to within the allowable range(4.2 ~ 8.5 V) and turn on the
power again, or set the LFSW(Pin-2) of the CPU to Active.
At the lower limit(Less than 0°C), printing is enabled at 0°C or more.
At the upper limit(65°C or more), printing is enabled at 60°C or less.
Eliminate the paper jam and set LFSW(Pin-2) of the CPU to Active or turn
on the power again.
26
CBM-202PC-04 User's Manual
Resetting Method
See Note 2.
A maximum
CITIZEN
Advertisement
