Post Numeric Codes And Text Messages - HP Dx5150 - Compaq Business Desktop Reference Manual

Hp business desktop dx5150 series service reference guide, 1st edition
Hide thumbs Also See for Dx5150 - Compaq Business Desktop:
Table of Contents

Advertisement

POST Error Messages

POST Numeric Codes and Text Messages

This section covers those POST errors that have numeric codes associated with them. The section
also includes some text messages that may be encountered during POST.
The computer will beep once after a POST text message is displayed on the screen.
Numeric Codes and Text Messages
Code/Message
BIOS ROM checksum
error–System halted
CMOS battery failed
CMOS checksum
error—Defaults
loaded
CPU at nnnn
Press ESC to skip
memory test
HARD DISK INSTALL
FAILURE
Keyboard error or no
keyboard present
Memory Test:
C–2
Probable Cause
The checksum of the BIOS
code in the BIOS chip is
incorrect, indicating that the
BIOS code may have become
corrupt.
The CMOS battery is no
longer functional.
Checksum of CMOS is
incorrect, so the system loads
the default equipment
configuration. A checksum
error may indicate that CMOS
has become corrupt. A weak
battery may have caused this
error.
Displays the running speed of
the CPU.
Cannot find or initialize the
hard drive controller or the
drive.
Cannot initialize the
keyboard.
This message displays during
a full memory test, counting
down the memory areas being
tested.
361685-001
Recommended Action
Verify the correct ROM.
Flash the ROM is needed.
If an expansion card was recently added,
remove it and see if the problem remains.
Clear CMOS.
If the message disappears, there may be a
problem with the expansion card.
Replace the system board.
Replace the RTC battery.
Check the battery and replace, if necessary.
None.
The user may press ESC to skip the full memory
test.
Make sure the controller is installed correctly in
the BIOS. If no hard drives are installed, be
sure the Hard Drive selection in Setup is set to
NONE.
Make sure the keyboard is attached correctly
and no keys are pressed during POST. To
purposely configure the system without a
keyboard, set the error halt condition in Setup
to HALT ON ALL, BUT KEYBOARD. The BIOS
then ignores the missing keyboard during
POST.
None.
Service Reference Guide, dx5150

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx5150 series

Table of Contents