Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
7.10 Power Switch Assembly
1. Prepare the computer for disassembly
2. Remove the front bezel
3. Rotate the drive cage to its full open position.
4. Disconnect the power switch/LED cable from the system board.
5. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
7–22
(Section 7.1, "Preparation for
(Section 7.4, "Front
Bezel,").
361685-001
Disassembly").
Service Reference Guide, dx5150