Setting A Cue Point; Setting A Cue Point On-The-Fly During Recording; Viewing Cue Points - Fostex UR-2 Owner's Manual

Starting recording
While the unit is in the input monitor mode, press
the [REC] key to start recording. The [REC RDY] in-
dicator changes from flashing to lighting, while the
[REC] indicator lights.
When you start recording for the first time, the unit
creates the "BWFF" folder, in which the recorded
files are stored. Each time you make recording, a
new file is created. (You cannot overwrite an exist-
ing file.)
PLAY
T MODE TIME REC RDY
EDIT REPEAT
FILE SEL DISPLAY
UR-2
STEREO RACK MEMORY RECORDER
STRG SEL
[REC] key
After recording starts, the display changes as fol-
lows.
To stop recording, press the [STOP] key.
To exit the input monitor mode, press the [REC RDY]
key.
With the default settings. each time you
<Memo>:
make recording, the unit creates a file with the
file name including the counted-up take num-
ber, as follows.
(Example): SCENE_001.wav, SCENE_002.wav
To play back the recorded audio file
<Memo>:
after recording, press the [REW] key while hold-
ing down the [STOP] key to skip to the begin-
ning of the file, and press the [PLAY] key.
To select a desired file from multiple files, use
the [ ] and [ ] keys or use the file selection
screen (see page 42).
MENU / ENTER
EXIT FILE/CURSOR CUE/LOCATE
MRGN RST PREV CUE NEXT TIME EDIT
REC STOP PLAY REW F FWD
MIN
INPUT LEVEL
ABS 0
REC END

Setting a CUE point

You can set a CUE point at the desired position of
a file by using two methods described below.
A CUE point can be used as a marker which you
can easily skip to, as well as used as the start or
end point of a file in the chain play list or timer
play list.
1) While recording an audio signal, you can set a
CUE point on-the-fly at the desired position.
2) Using the CUE list screen, you can set a CUE
point.
MAX
Setting a CUE point on-the-fly during re-
cording
By pressing the [CUE/LOCATE] key at the desired
position during recording, a new CUE point is set.
You can set up to 99 CUE points for each file.
MENU / ENTER
EXIT
MRGN RST
STOP PLAY
ABS 0
REC END
When you set a CUE point on-the-fly, the popup
window as above briefly appears. Each time you set
a CUE point, the CUE number is counted up by one.

Viewing CUE points

Pressing the [CUE/LOCATE] key while the unit is
stopped brings up the CUE LIST screen, on which
you can view the existing CUE points.
In the following example, CUE 01 through CUE 04
are set.
A CUE label is automatically set. CUE labels for
CUE01 and CUE02 are "BC$START" and "BC$END"
respectively, which are reserved by the BWF-J speci-
fications.
-35-
Model UR-2 <Recording>
[CUE/LOCATE] key
PHANTOM
FILE/CURSOR CUE/LOCATE MIC IN
PREV CUE NEXT TIME EDIT MIC SET
REW F FWD
MIN MAX MIN MAX
INPUT LEVEL MIC GAIN MIC IN
<Popup window wexample>